Cisco 400-201 Exam Dumps For Success

Passing the 400-201 exam questions using the assist of Dumpsschool new 400-201 exam dumps 2020: pdf questions are prepared by experienced and certified Cisco expert. Pass Cisco exam with confidence. Download the free demo of Cisco exam dumps right now.

Try it Latest DumpsSchool 400-201 Exam dumps. Buy Full File here: https://www.dumpsschool.com/400-201-exam-dumps.html (699 As Dumps)

Download the DumpsSchool 400-201 braindumps from Google Drive: https://drive.google.com/file/d/1keAzpsvJwLMJ1MmaK28b34t3vZ9J1NnN/view (FREE VERSION!!!)

Question No. 1

The origin is a mandatory attribute that defines the origin of the path information.

Which three options are valid origin attributes? (Choose three.)

Answer: C, D, E

Question No. 2

Which option describes a service function as defined in SDN?

Answer: C

Question No. 3

Refer to the exhibit.

Refer to the exhibit R7 and R8 unable to create IBGP session. What is the source of the Issue?

Answer: A

Question No. 4

Which mode does PPP interface use for peer authentication?

Answer: C

Question No. 5

A VPLS network consists of provider edge routers that have fully meshed pseudowires, the network runs unicast and multicast traffic, the network recently experienced bandwidth and CPU-related performance issue While monitoring the VPLS and interface statistics an operations engineer notice that the network is experiencing an unusual amount of broadcast and undesired multicast traffic. Which two technique can address these issue?(choose two)

Answer: D, E

Question No. 6

Refer to the exhibit

Refer to the exhibit ACME Enterprise is running DMVPN with spoke-to-spoke communication 2547oDMVPN has been implemented to extend MPLS to all other branches. What is the traffic flow behavior between branches after 2547oDMVPN implementation?

Answer: A

Question No. 7

A network engineer is requested to have load sharing over two links to the same destination prefix. The traffic share for the first link must be two times the traffic share of the second link. Which two protocols can fulfill this requirement? (Choose two.)

Answer: A, B

Question No. 8

Which statement is FALSE concerning Concatenation?

Answer: B

Question No. 9

Assume two routers on the same subnet, R1 and R2, both configured for HSRP. R1 has a priority of 120. Which of the following HSRP interface configurations will always result in the R2 becoming the primary? (Choose two.)

Answer: B, C

Question No. 10

A service provider is in the process of providing Layer 2 and Layer 3 VPN services through a MPLS LDP-enabled backbone. With load increasing in the service provider domain, scalability become the most important. Based on the local label allocation filtering failure, which subnet of prefixes must be selected to meet these requirements?

Answer: B

Question No. 11

GMPLS is based upon:

Answer: B

The Generalized Multi-Protocol Label Switching (GMPLS)[1] is a protocol suite extending MPLS to manage further classes of interfaces and switching technologies other than packet interfaces and switching, such as time division multiplex, layer-2 switch, wavelength switch and fiber-switch.

GMPLS is composed of three main protocols:

Resource Reservation Protocol with Traffic Engineering extensions (RSVP-TE) signaling protocol.[5][6]

Open Shortest Path First with Traffic Engineering extensions (OSPF-TE) routing protocol.[7][8]

Link Management Protocol (LMP).[9]

Question No. 12

A network engineer is asked to connect two customer sites using Layer 2 connectivity over an MPLS backbone. One customer site uses PPP connectivity with the service provider and the other customer site uses Frame Relay connectivity with the service provider. Which option can the network engineer use to enable network connectivity between these two customer sites?

Answer: B

Question No. 13

Refer to the exhibit.

Refer to the exhibit. displays the Router_3 FIB information without any OSPF LSDB optimization. An engineer wants to optimize the OSPF LSDB in accordance with RFC 1587 Considering the following restraints:

*Router_3 maintains full connectivity

*Router_2 requires the least configuration

In orderto achieve the OSPF LSDB optimization on Router_3. which Cisco IOS command should the engineer use on Router_2?

Answer: F

Question No. 14

Which option is the SONET frame format of the STM-4 SDH circuit?

Answer: C

Question No. 15

Why are thresholds defined based on baseline documents?

Answer: A

400-201 Dumps Google Drive: (Limited Version!!!)
https://drive.google.com/file/d/1keAzpsvJwLMJ1MmaK28b34t3vZ9J1NnN/view

Exam Vendor: Cisco dumps

         

Facebook Comments